Mityvac MV5565 FUEL INJECTION CLEANER Manuel d'utilisateur télécharger pdf (Page 14)

Page Number - 14 Form 801817

12. Connect one end of the Cleaner Hose to the outlet of

the Cleaner (Fig. 17), the other end to inlet of the Decarb

Adapter (Fig. 18).

13. Connect shop air supply to the Cleaner inlet. Ensure the

shop air pressure is no greater than 150 psi (10 bar)

(Fig. 19).

14. Start the vehicle and allow it to idle.

15. Return to the Cleaner and open the air inlet valve

(Fig. 20).

16. Rotate the regulator adjustment knob clockwise until the

pressure gauge reads approximately 60 psi (4 bar)

(Fig. 21).

17. Open the outlet valve to allow the cleaning solution to

spray into the air stream (Fig. 22).

At 60 psi (4 bar) pressure, it will take approximately

8 minutes to inject 12 oz (350 ml) of cleaning solution

into the air stream.

18. Close the air inlet valve when the canister is empty of

solution.

19. Turn off the car.

20. Allow the pressure to return to zero, and disconnect and

disassemble the Cleaner. Properly dispose of any unused

cleaning solution.

21. Remove the nozzle from the air induction system and

re-secure the air intake hose.

Note: Do not start the engine for 30 minutes. This will

allow the solution to soften and dissolve the carbon

deposits. After 30 minutes, test drive the vehicle for at

least 15 minutes to ﬂush carbon deposits out of the

system.

Figure 19

Figure 20

Figure 22

Figure 21

Figure 18

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 43 44

Pas de commentaire

Mityvac MV5565 FUEL INJECTION CLEANER Manuel d'utilisateur Page 14